Painduv 8x32 RGB LED Maatriks Vaata suuremalt

Painduv 8x32 RGB LED Maatriks

EN86

uus

4 toodet

laos, Tallinnas

108,00 €

Lisa soovinimekirja

Rohkem infot

SPECIFICATION

  • Operating Voltage: 5V
  • LED Type: SK6812/WS2812
  • Communication Interface: Gravity 3Pin interface
  • Operating Temperature: -25 ~ +80 ℃
  • Dimension: 80*320 mm/3.15*12.60 inches
  • Weight: 188g

INTRODUCTION

 This module is a square panel with a soldered XH2.54 3-pin interface with pin mappings.

This flexible 8x32 RGB full-color LED matrix module is based on WS2812 or SK6812 intelligent control LEDs. Each LED can be independently addressed with RGB pixels that can achieve 256 levels of brightness. That’s 16777216 colors in total with a scanning frequency no less than 400Hz.

The LED panel is single wire control board.  Customized with a special cable to make it compatible with Arduino I/O expansion shields without any soldering. The module also supports cascading control. All you need to do is connect Din to the DOUT port. In combination with the open source Arduino library, you can control an entire array of LEDs using just one pin.

Note: 
Each LED requires a maximum current of 18mA. When multiple modules are in use, it is recommended to use the DFRobot Gravity IO expansion board to power multiple LEDs matrix via the Servo Power Port.

FEATURES

  • Full Color RGB
  • Supports Cascade Control
  • Compatible with Gravity Interface
  • Supports External Power Supply

DOCUMENTS

Product Wiki

SK6812 Andmeleht